Philips FWD410/51, Service Manual

Page: 11 / 33

3 - 1 3 - 1
DISASSEMBLY INSTRUCTIONS
Figure 1 Figure 2
Figure 3
2) Open the BD Tray by using the Open/Close Button while the Set is ON and disconnect the mains supply after removing the DVD
Door.
3) Return the set to its upright position and remove the Tray Cover as shown in Figure 3 and close the tray manually by pushing it back
in.
4) Loosen 4 screws remove the front panel.
- 1 screw “C” each on the left & right side as shown in fi gure 4.
- 2 screws “D” at the bottom of the set as shown in fi gure 5.
Dismantling of the Top & Front Panel Assemble
1) Loosen 14 screws and remove the Top Cover by lifting the rear portion upwards before sliding it out towards the rear.
- 6 screws “A” at the back panel as shown in fi gure 1.
- 4 screw “B” each on the left & right side as shown in fi gure 2.
Dismantling of the DVD LOADER & LOader brakcet
1) Loosen 4 screws “E” on the top of DVD Loader as shown in fi gure 6.
2) Loosen 2 screws “F” at the back panel as shown in fi gure 7.
Figure 6
Figure 4
Figure 9
Note:In some service positions the components or copper patterns of one board may risk touching its neighbouring pc boards or
metallic parts. To prevent such short-circuit use a piece of hard paper or other insulating material between them.
A
B
C
D
Figure 5
E
F
Figure 7
Dismantling of the MAIN Board
1) Loosen 2 screws “G” on the top of Main board as shown in fi gure 8.
2) Loosen 7 screws “H” at the back panel as shown in fi gure 9.
Figure 8
G
H
Dismantling of the POWER Board
1) Loosen 4 screws “I” on the top of Power board as shown in fi gure 10.
Figure 10
I