2-1
2-1
DISMANTLING INSTRUCTIONS
1) Loosen the 4 screws, slide Cover top (pos 255) towards
the rear and remove it upwards.
2) Loosen 3 screws slide the Panel right (pos 254) towards
the rear and remove it outwards. Do likewise for the Panel
left (pos 253).
3) Push the gear slowly towards the front as shown in figure
2 until the CDC tray starts to move out of the Front Cabinet
(pos 101). The CDC tray is now disengage and can be
pulled out completely.
Dismantling the 3CDC Module
4) Remove the Cover Tray (pos 106) as shown in figure 1.
5) Loosen 4 screws A to remove the CDC Module (pos 1104)
as shown in figure 2.
A
A
A
Turn the Gear towards the Front
till the CDC Tray starts to open
Figure 2
Figure 1
Dismantling of the Volume & Jog Rotary knobs
1) Cut a piece of packaging tape approximately 5cm width by
12cm length and tape its narrow side on to the top and
bottom side of the Volume knob (pos 139) as shown in
figure 3.
Dismantling of the Front Panel assembly
1) Loosen 2 screws below the Front Panel (pos 101) mounting
it to the Bottom plate (pos 265).
2) Release the 2 catches on the sides of the Front Panel to
separate it from the Bottom plate.
3) Remove the Volume and Jog Rotary knob if the Front
board needs to be dismantled. For Karaoke versions, the
Karaoke knob (pos 133) also need to be removed.
4) Loosen 8 screws B to remove the Front board as shown in
Figure 5.
5) Loosen 6 screws C and eject both cassette doors to
remove the Tape mechanism (pos 1103) as shown in figure
6.
Note: The Cassette door can be removed only after
the removal of the Tape mechanism and buttons.
2) Place a small screw driver in between the tape & knob (see
figure 3) to give more leverage in pulling out the knob as
shown in figure 4.
3) Do likewise for the Jog Rotary knob (pos 138). You may
have to rotate the knob to provide the most exposed area
during application of the packaging tape.
Figure 4
Figure 3
Figure 5
Figure 6
