Philips FM-2, Service Manual

Page: 13 / 110

Chapter 1 - General Information
1
1
General Information
Introduction
This guide tells you how to service and repair the monitor (M2922A). It
describes the system hardware and software, tells you how to diagnose operating
and servicing problems, and how to test the system.
As this monitor is intended to be installed by the customer, refer to the
Instructions for Use for details of how to install the monitor.
The FM-2 Antepartum Fetal Monitor Service Guide supplements the
maintenance and troubleshooting procedures carried out by the operator that
are described in the Instructions for Use. Refer to the Instructions for Use for
maintenance and troubleshooting procedures that may be performed during
normal operation.
Any other maintenance and repair procedures beyond the level covered in the
Instructions for Use are limited to replacement of:
• the battery
• three board assemblies inside the case (but excluding the main PCB)
• the speaker
• components of the LCD display installed in the front case assembly
The features available on the monitor you are servicing depend on which
accessories were purchased. As this manual covers all accessories, consult your
configuration listing to see which apply to your monitor.
As the only support strategy for the Recorder is unit exchange, in the event of a
malfunction or failure, no repair or servicing information for it is included in
this manual. For routine care and maintenance, refer to the Instructions for Use.
Only qualified service personnel should attempt to disassemble the monitor, or
to remove or replace any internal assemblies.