8
EN
Subwoofer
This section includes an overview of the
wireless subwoofer.
25Hz
9
8
7
10
1
2
3
5
4
6
1
(Wi-Fi Setup) button / indicator
•
Trigger Wi-Fi setup for Play-�.
•
Press and hold the button for 8
seconds to active the AP mode.
•
Press and hold the button for 4
seconds to active the WPS mode.
•
Press and hold the button for
15 seconds to reset the factory
default settings of the subwoofer.
Action
LED State
Status
Constant
on
Connected
/ Pairing
successful
Press and
hold 8
seconds
Blink
Wi-Fi Access
Point (AP)
mode
Press and
hold 4
seconds
Double
blink
Wi-Fi Protected
Setup (WPS)
mode
2 Power/RF link indicator
3
Source (switch Play-fi/FR link/Sub
in mode)
• When FW1 is used as a wired
subwoofer, source switch must be
at Sub in position.
»
All network audio functionality
will stop working.
»
Wi-Fi is disconnected but Wi-Fi
credentials shall be retained if it is
setup previously.
»
Play-� module can be turned off.
•
To upgrade �rmware for Play-�
module and MCU via USB service
port, source switch must be at
Sub
in
position.
4 USB service socket
The USB socket is for service only.
5 Reset button (Pin hole)
Reset device to default setting.
6 Phase 0° - 180° (switch)
7 Sub in (socket)
Use the subwoofer cable to connect
the subwoofer to the soundbar (not
supplied).
8 Crossover 25Hz-150Hz (knob)
9 Gain +/- (knob)
Functional Settings
Default
Gain
-6 dB to +6 dB
0 dB
Crossover 25 to 150 Hz
-
Phase
0 or 180 degree
0 degree
When FW1 as Play-� subwoofer,
above controls and functions are not
applicable.
10
AC in
~
socket
Connect to the power supply.
