24
4
Follow the on-screen instructions to
complete the firmware update.
Note
•
In case the firmware update fails, you can try the above
procedures again.
•
After successful firmware update, if there is any
problem with the Wi-Fi connection, press and hold
both the
+
and
-
buttons on DS3881W for more than
5 seconds at the same time to reset the device, and
then try to set up the Wi-Fi network for DS3881W
again (see ‘Connect to your home Wi-Fi network for
AirPlay’ on page 12).
Update from the
configuration page
Warning
•
Always connect your DS3881W to AC power for
firmware upgrade. Never power off your DS3881W
during firmware upgrade.
Note
•
To use an Internet browser other than Apple Safari
on your PC/Mac, remember to go to the Wi-Fi router
configuration page and write down the IP address of
your DS3881W. See the user manual of your Wi-Fi
router for how to find the IP addresses of devices
connected to the Wi-Fi router.
1
Power on DS3881W (see ‘Prepare’ on
»
It takes about 35 seconds for the unit
to boot up. During boot-up, the
WI-FI
SETUP
indicator on the back of the
unit blinks green quickly.
»
After boot-up, you can hear a beep
and the
WI-FI SETUP
indicator
turns to green steadily. DS3881W is
connected to the last configured Wi-Fi
network automatically.
2
Make sure that DS3881W and your PC/
Mac are connected to the same Wi-Fi
router.
3
Open Apple
Safari
on your PC/Mac, then
select ‘Philips_Fidelio XXX’ from the
Bonjour pull-down list.
•
Or open any other Internet browser
on your PC/Mac, then type in the IP
address of DS3881W (available on
the Wi-Fi router configuration page)
at the address bar.
»
The DS3881W configuration
web page is displayed.
EN
