FC8261/01
DISASSEMBLY- AND RE-ASSEMBLY ADVISE
- First remove the dust bag.
- Remove the dustcover using a screwdriver (see picture).
- When the dustcover has been removed, the 5 screws
A
that
need to be unscrewed to disassemble the upper housing, are
accessible.
A
A
A
A
A
- After removing screw
B
, lift the motor cap (item 20) out of
the lower housing to be able to take out the cord winder
unit.
B
- To disassemble the cord winder, use TORX screwdriver
no. T10, which is one of a set consisting of T20; T15; T10;
T9; T8; T7 and T6 (code number 4822 395 50145).
- During re-assembling, take care the wires are positioned in
the guides correctly.
REPAIR INSTRUCTION
- The spare parts have been standardized as much as possible.
- Depending on the original cord, the spare cord must be
shortened to the length of the original cord.
- The cord winder spring must be tensioned to the maximum
level and then be rewound approx. 1.5 turn
- If the reel half spring unit is replaced, shaft
D
must be
lubricated with silicone grease. Do not apply any silicone
grease to or spill any grease on terminals (item 34) or
conductors (item 33).
- Item 7, air valve, opens to cool the motor if the air
displacement is too low or if the airflow is blocked.
ELECTRICAL DIAGRAM
M
SPEED
CONTROL UNIT
CORD WINDER
C
2-6
