INSTALLATION INSTRUCTIONS
F Series Floodlight
© 2016 Philips Lighting Holding B.V. All rights reserved.
www.philips.com/luminaires
Part Number 443561002550 Rev. F
Page
7
of
7
Philips Lighting North America
Philips Lighting Canada Ltd.
Corporation
281 Hillmount Road,
200 Franklin Square Drive, Markham ON, Canada L6C 2S3
Somerset, NJ 08873, USA
WB-5 Surface Wiring Box
For use with WB-1 wall bracket. Serves
as a wiring compartment and used where
surface mounted conduit feed is used.
Tapped at top, bottom, and back for 3/4”
NPT conduit. Gasket provided for
sealing box to the WB-1. Mounting
hardware (1/2” mounting bolts) provided
by user. The WB-5 box is supported by
the same bolts used to support the WB-1
and need to be long enough to secure
both the WB-1 and box to the wall. The
box straddles the four mounting bolts.
(See
FIGURE 20).
TH-1 Hanger for Less Ballast Models
For mounting floodlights on standard
lowering devices (by others). Base of
TH-1 is tapped for 1-1/4” NPT conduit.
For 1” tap a 1-1/4” to 1” reducer
(provided by user) is required. Thread
TH-1 on to lowering device and tighten
set screw to lock to the stem. Install
floodlight to TH-1 covered in steps 4 and
5 of fixture assembly.
(See
FIGURE 21
).
