INSTALLATION INSTRUCTIONS
F Series Floodlight
© 2016 Philips Lighting Holding B.V. All rights reserved.
www.philips.com/luminaires
Part Number 443561002550 Rev. F
Page
6
of
7
NEC and local codes. Follow wiring
instruction on ballast.
IMPORTANT:
If
high
pressure
sodium remote ballast is used make
sure the ballast is installed within the
distance limitations published by the
ballast manufacturer.
PCM-1 Photocell Receptacle Only
Remove 1/2” pipe plug from the ballast
mastfitter
base.
Thread
the
1/2”
photocell receptacle into the mastfitter
base, tighten securely. Check to see that
the photocell (provided by user) is of
proper voltage and wattage. Wire in
accordance to wiring diagram.
(See
FIGURE 15).
WG-10 or WG-4 Wireguard
Attach wireguard to cored holes on top
and bottom of fixture with thread cutting
screws provided in kit (see
FIGURE
16
).
MF-1 Mastfitter for Less Ballast
Models
Allows fixture head to be remote
mounted on a vertical 2-3/8” OD tenon x
4-1/2” tall. Attach fixture mounting arms
to the MF-1 using hardware as covered
in steps 4 and 5 of fixture assembly.
Remove pipe plug from MF-1 and route
S.O. cord through a watertight cable
connector (provided by user) for internal
wiring to the remote ballast. Or, wiring
can be external to an appropriate
junction box or similar device (See
FIGURE 17
).
HV-1 Trunion Base for Less Ballast
Models
Can be mounted to any suitable
horizontal or vertical surface suited for
the purpose. Calibrate in 10° increments
(0°-90°) for horizontal adjustment. There
are three mounting holes, 7/16” nominal
diameter for 3/8” mounting bolts
(provided by user) for mounting the
HV-1 attach fixture mounting arms to the
HV-1 using hardware as covered in steps
4 and 5 of fixture assembly (See
FIGURE 18
).
WB-1 Wall Mounting Bracket
For mounting floodlight with ballast or
less ballast models to a flat vertical
surface only. There are four 9/16”
nominal mounting holes in the back plate
for 1/2” mounting bolts (provided
by user). Wiring of fixture can be done
internally
(see
wiring
instructions)
through the bracket for applications
where the wiring box is flush mounted.
Or, can be wired externally to an
appropriate junction box or similar
device. (See
FIGURE 19).
WG-10, WG-4
AL-10, AL-4
