Installation & Operation Guide
eS21 LED Raceway
1 0
DIMMER SYSTEM FUNDAMENTALS
LED Modules
Each eS21 LED Raceway LED Module contains four channels of LED luminaire control. The module is a LED
power supply that is designed to deliver power and data (through its four low-voltage connectors) to power and
control any Selecon PL Wash luminaire or Color Kinetics Blast fixtures. See
Figure 2
for details.
Figure 2: LED Module Focus Buttons / LED Indicators
LED Module - Focus Buttons
The Focus Buttons can be used to quickly operate or test the fixtures as follows:
• Tap - toggles fixtures from OFF to ON (or ON to OFF) on all channels if DMX512 signal is not present.
• Hold - turns fixture ON to 100% (all channels) if DMX512 signal is present. Returns to DMX level when button is
released.
LED Modules - LED Indicators
The two LEDs associated with each channel report various operating conditions. The Red LED turns on for
approximately 4 seconds on power-up, and after that the indications are as follows:
LED Modules - Data / Power Connections
Below is a diagram on how to wire to the connectors in the LED Module 4-pin connectors.
WARNING!
This connector (on LED Modules) is for use with specified LED fixtures only. Use or connection of
any other device will damage module and void the eS21 LED Raceway’s warranty.
Red LED
Green LED
Condition
On
Off
No Communications with Head-End Processor
Off
On
Module is set to 100% by Focus button
Focus Button / Status LED Indicators
(one set for each channel)
1
2
3
4
Only for use with:
Philips
Color Kinetics
Philips
Selecon
iW Blast
PLW-WW
TR Blast
PLW-RGB
TRX Blast
PLW-RGBAW
LED Module 4-Pin Connector Pinout:
Pin
Signal
1
+24 Volts DC
2
Not Used
3
Data
4
Ground
Summary of Contents for eS21
Page 1: ......
Page 29: ...eS21 LED Raceway 230V 240V Model 71900 27 eS21 LED Raceway Installation Operation Guide Notes ...
Page 30: ......
