Alignments
8.
8.3.7
GEO-SW (Super Wide geometry alignment in 16:9 sets)
You only need to set the following values (if the normal
geometry alignment has been performed correctly):
1.
V. S-CORRECTION: enter value of the NORMAL
GEOMETRY alignment.
2.
H. AMPLITUDE: enter value of the NORMAL GEOMETRY
alignment subtracted by "1".
3.
EAST/WEST PARABOLA: enter value of the NORMAL
GEOMETRY alignment.
8.3.8
GEO-100HZ (Digital Scan geometry alignment)
As all alignments are done in Pixel Plus mode (at 75 Hz), the
100 Hz mode needs an extra alignment:
•
Select GEO-100HZ. The set automatically switches to 100
Hz mode.
•
V. SLOPE: match the middle line of the test pattern with the
upper edge of this blanking picture.
•
After the alignment, return to the previous menu. The set
automatically returns to "Pixel Plus" mode.
8.4
Option Settings
8.4.1
Introduction
The microprocessor communicates with a large number of I2C
ICs in the set. To ensure good communication and to make
digital diagnosis possible, the microprocessor has to know
which ICs to address. The presence / absence of these specific
ICs (or functions) is made known by the option codes.
•
You can set the "hardware related" options via the SAM -
ALIGNMENTS - OPTIONS or OPTION NUMBERS menu.
•
You can set the "software related" options via the SAM -
DEALER OPTIONS menu.
Notes:
•
After changing the option(s), save them with the STORE
command.
•
The new option setting is only active after the TV is
switched "off" and "on" again with the AC power switch (the
EAROM is then read again).
8.4.2
DEALER OPTIONS
Select this sub-menu to set the initialisation codes (= options)
of the set via text menu's.
Table 8-5 Dealer options overview
Menu name Subjects
Options
Physically in set
Personal
Options
Picture Mute
Yes
Picture (blue) mute active in
case no picture detected
No
Noise in case of no picture
detected
Virgin Mode
Yes
TV starts up (once) with
language selection menu after
mains switch on for the first
time (virgin mode)
No
TV does not start up (once) with
language selection menu after
mains switch on for the first
time (virgin mode)
Auto Store Mode
(only for EU and
AP-PAL sets)
None
Autostore mode disabled (not
in installation menu)
PDC-VPS
Autostore mode via ATS (PDC/
VPS) enabled
TXT page
Autostore mode via ACI
enabled
PDC-VPS-TXT Autostore mode via ACI or ATS
enabled
TXT Preference
(only for EU and
AP-PAL sets)
TOP
Preference to TOP Teletext
FLOF
Preference to FLOF Teletext
http://jdwxzlw.5d6d.com/?fromuser=森林
家电维修资料网
免费下载各种维修资料