RIGHT
45°
LEFT
45°
RIGHT
90°
LEFT
90°
FIGURE 7a
The lights can be adjusted 37.5° downward. For the
PIR sensor, on the rear side of motion sensor is an
adjustment bar which can be used to adjust the angle of
PIR sensor to up to 30° downward. (FIGURE 7b)
30°
37.5°
adjustment
FIGURE 7b
SETTING THE LIGHTING SYSTEM
(1) TEST MODE
Turn the LUX control and the TIME control
counterclockwise to the edge
– the TEST position.
(FIGURE 8)
Time
5S
12min
Lux
FIGURE 8
Turn on the wall switch. The unit will start warming
up for about 60 seconds. After warm-up it will
automatically revert to normal operation. During the
warm-up period the lights will stay on.
Walk through the detection area. The lights turn on
when you move and turn off when you stop. Wait
until the lights turn off and then move again to test
the sensor.
Adjust the motion sensor to cover the desired
detection area. For a smaller coverage area, point
the sensor down; for a larger coverage area, point
the sensor up.
(2) TIME ADJUSTMENT
The TIME adjustment controls how long the light will stay
on after motion has been detected.
Turn the TIME control knob clockwise to increase (up to
12 minutes) the period the lights stay on or counter
clockwise to decrease (down to 5 seconds) the time
delay (FIGURE 9).
Time
5S
12min
Time
5S
12min
FIGURE 9
(3) LUX ADJUSTMENT
The LUX control knob determines at which ambient Lux
level the lights will turn on when the sensor is in
Automatic Operation mode.
The adjustable Lux range is between 30 and 200 Lux.
Turn the LUX control knob clockwise to the MOON
position and the lights will only turn on at night (below 30
Lux). Turn the LUX control knob counterclockwise to
increase the Lux setting. Adjust the control knob
depending on your requirements.
Lux
FIGURE 10
OPERATION
Depending on your needs, you can switch the unit
between the following operation modes: Automatic
Operation and Manual Override.
(1) Automatic Operation
Turn on the wall switch. After about 60 seconds
warm-up the sensor will enter Automatic Operation.
When the sensor detects motion and the ambient light
level is lower than the LUX setting, the lights will
automatically turn on. The lights will stay on for the
duration of TIME setting and then turn off. Note that if
motion is detected again while the lights are still on, the
time counting will be reset.
Adjustment
Bar
