Software upgrade
Preparation to upgrade software
1) Start the CD Burning software and create a new CD
project (Data Disc) with the following setting:
B. Read out the software versions to confirm upgrading
Label: DVP3XXX
(No need the label name)
File Name:
DVPXXXX_XX.BIN
1) Power on the set and press <Setup> button on the
Power on the set and open the tray, then press <option>
remote control.
to check the File Name.
2) Press <Next><Next><Prev><Prev> button.
The software version and other information are display
Note: It is required capital letter for the File System
on the TV screen as follows:
name.
Version XX.XX.XX.XX (Main version)
2) Burn the data onto a blank CDR
SUB-VER XX.XX.XX.XX (software version of
application software)
A. Procedure for software upgrade:
8032 XX.XX.XX.XX
1) Power on the set and insert the prepared Upgrade
Servo XX.XX.XX.XX (software version of servo)
CDR.
RIS XX.XX.XX.XX
2) The set will starts reading disc & response with the
DSP XX.XX.XX.XX
following display TV screen:
Region Code X
Upgrade File DETECTED
Upgrade?
Press Play TO START.
3) Press <OK> button to confirm, then screen will display :
Files coping…
Caution: The set must not be power off during
UPGRADING…
upgrading, Otherwise the Main board will be
4) The upgraded tray will automatically open when files
damaged entirely.
coping complete, then take out the disc.
5) About 1 minute later, the trace will automatically close
when upgrading complete.
3-1
