19
No audio output from the loudspeakers of the
audio device (stereo system/amplifi er/receiver).
Ensure that the audio cables are connected to
•
the audio input of the audio device.
Turn on the audio device to its correct audio
•
input source.
No sound during DivX video playback
The audio codec may not be supported by this
•
product.
Play
The disc cannot be played.
The disc is badly scratched, deformed, or dirty.
•
Replace or clean the disc.
Use the correct disc format or fi le format.
•
DivX video fi les cannot be played.
Ensure that the DivX video fi le is complete.
•
Ensure that the fi le name extension is correct.
•
Due to Digital Rights issue, the DRM-
•
protected video fi les cannot be played through
an analog video connection (e.g. composite,
component and scart). Transfer the video
content onto the Disc Media and play these
fi les.
The aspect ratio of the screen is not aligned with
the TV display setting.
The aspect ratio is fi xed on the disc.
•
DivX subtitles are not displayed correctly.
Ensure that the subtitle fi le name is the same
•
as the movie fi le name.
Select the correct character set.
•
Press
•
.
Select
•
[Preferences]
>
[DivX Subtitle]
in
the menu.
Select the character set that supports the
•
subtitle.
9 Troubleshooting
Warning
Risk of electric shock. Never remove the casing of the
•
product.
To keep the warranty valid, never try to repair the
product yourself.
If you have problems using this product, check the
following points before you request service. If you
still have a problem, register your product and get
support at www.philips.com/welcome.
If you contact Philips, you will be asked for the model
and serial number of your product. The model
number and serial number are on the back of your
product. Write the numbers here:
Model No. __________________________
Serial No. ___________________________
Main unit
The buttons on this unit do not work.
Disconnect this product from the power
•
outlet for a few minutes, then connect again.
No reaction to the remote control.
Connect this product to the power outlet.
•
Point the remote control at the IR sensor
•
located on the front panel of this product.
Insert the batteries correctly.
•
Insert new batteries in the remote control.
•
Picture
No picture.
See the TVs user manual on how to select
•
the correct input on the TV. Change the TV
channel until you see the Philips screen.
If you have turned on the progressive scan
•
setting or change the TV system setting,
switch back to default mode: 1) Press to
open the disc compartment. 2) Press the
Numeric button ‘1’
(for progressive scan) or
the
Numeric button’3’
(for TV system).
Sound
No audio output from the TV.
Ensure that the audio cables are connected to
•
the audio input of the TV.
Assign the audio input of the TV to the
•
corresponding video input. See the TV user
manual for details.
English
EN