49
EN
Recording
Playback
Editing
Introduction
Connections
Basic Setup
Function Setup
Others
49
EN
Note for DV dubbing
• If you press
[PAUSE
F
]
at step 5, the tape will rewind to the point a few seconds preceding the paused point
when you press
[OK]
at step 6, then, it will start dubbing when it comes to the paused point.
• The unit does not send out the output signal to DVC.
• For the proper operation, connect DVC to the unit directly. Do not connect this unit and DVC via any other unit.
• Do not connect more than 1 DVC.
• The unit can only accept DVC. Other DV device such as cable/satellite box or D-VHS VCR cannot be recognized.
• If no video signal is detected from the DVC during DVC to DVD dubbing, the recording will be paused and “
I
” will
flash on the TV screen. The recording will resume when the unit detects the video signal again.
• When the DVC is in camera mode, refer to “Guide to DV and On-Screen Display” on page 47.
• You cannot dub from DVC during timer standby mode.
• Date / time and cassette memory data will not be recorded.
• Pictures with a copy-guard signal cannot be recorded.
• A DV terminal is a terminal that can use the transmission mode conforming to the IEEE 1394 standards called “Fire
Wire”. It enables digital dubbing between DV devices with little degradation.
DV DUBBING
5
Press [PLAY
B
] to find the point
where you wish to start dubbing.
Then, press [STOP
C
] where you wish
to start dubbing.
6
Use [
K
/
L
] to select “Start Rec”, then
press [OK].
The dubbing will start.
7
To stop dubbing;
Use [
K
/
L
] to select “Control”, then
press [OK].
Use [
K
/
L
] to select “DVD”, then
press [OK].
Then press [STOP
C
].
E7H42UD_DVDR3506-37_EN.indd 49
E7H42UD_DVDR3506-37_EN.indd 49
2007/12/28 10:53:26
2007/12/28 10:53:26
