8239 300 38592
WARNING
Under no circumstances should you try to repair the system yourself, as this will
invalidate the warranty. Do not open the system as there is a risk of electric shock.
If a fault occurs, first check the points listed below before taking the system for repair. If
you are unable to remedy a problem by following these hints, consult your dealer or
Philips for help.
No power.
No sound or distorted sound.
There is no sound from the
cent
e
r
and
rear speakers.
Radio reception is poor.
The remote control does not function
properly.
Low hum or buzz sound.
– Check if the AC power cord is properly
connected.
– Adjust the volume.
– Check the speaker connections and settings.
– Disconnect the headphones.
–
Press the correct source button on the
remote (TV or AUX, for example) to choose
the equipment that you want to hear through
the AV receiver.
–
Press CENTER
+-
or REAR
+-
to
adjust the
volume level.
– Make sure the cent
e
r and re
ar speakers are
connected correctly.
–
Press SURROUND button to select a correct
surround sound setting.
–
Make sure the source you are playing is
recorded or broadcast in surround sound
(DTS, Dolby Digital, etc.).
–
If the signal is too weak, adjust the antenna or
connect an external antenna for better
reception.
–
Increase the distance between the system and
your TV or VCR.
–
Tune in to the correct frequency.
–
Place the antenna farther away from any
equipment that may be causing the noise.
–
Select the source (DISC or TUNER, for
example) before pressing the function button
(
S
,
T
).
–
Reduce the distance between the remote
control and the system.
–
Replace the batteries with new ones.
–
Point the remote control directly toward the
IR sensor.
–
Check that the batteries are loaded correctly.
–
Place the AV receiver as far away as possible
from electrical devices that may be causing
interference.
Problem
Solution
Troubleshooting
NEED HELP?
Visit our website www.philips.com/
support
23
English
usa