14
English
Test Tone
This feature enables you to check the sound level of the
respective front left/right, centre and surround speakers in
any mode except stereo mode.
You must sit at the ideal sitting position to perform
this operation.
1
Press
POWER
B
to switch on the system.
2
Press
TEST TONE
.
➜
A test signal is generated. It will move through the left,
centre, right, and surround speakers.
➜
The test signal will last for about 2-3 seconds.
Changing system settings-special circumstances
To ensure proper recording quality when you make a copy
of a DVD/CD via analogue output, set the speaker size to
F-LARGE
and set the surround mode to
STEREO
.
Selecting TV aspect
Select the appropriate screen type according to your TV
set. Conventional size screens use a 4:3 aspect ratio, and
wide-screens use a 16:9 ratio.
1
Press
SYSTEM MENU
.
2
At the setup menu, press
3
or
4
to select “
TV DISPLAY
”
then press
OK
.
3
Press
OK
repeatedly to select the desired aspect, then
press
SYSTEM MENU
.
16:9 WIDE (Wide screen)
– If you have a wide screen TV
set, use this setting. The DVD
plays in full size. (You must also
set your wide screen TV to “full
size”).
4:3 LB (Letterbox)
– If you have a conventional TV set
and your DVD is formatted for wide
screen viewing, use this setting. A
wide picture with bands is displayed
on the upper and lower portions of the TV screen.
4:3 PS (Pan and Scan)
– If you have a conventional TV
set and your DVD is not
formatted for wide screen
viewing, use this setting. A wide
picture is displayed on the whole TV screen with a portion
automatically cut off.
Note:
– If your DVD is not encoded to allow you to change the
aspect ratio, TV DISPLAY cannot be changed.
Selecting digital audio out
Each DVD has a variety of audio output options. If you
connected a device to the player’s digital optical jacks
(refer to “Connecting a Digital (Optical) audio device”),
you might have to change the digital audio output setting.
Set the player’s Digital Audio Output to the type of audio
system you use.
CAUTION!
If an active digital audio output signal is supplied
to a DVD system or other equipment without a
corresponding digital decoding capability, a very
loud noise might be produced which could
permanently damage your speakers.
1
Press
SYSTEM MENU
.
2
At the setup menu, press
3
or
4
to select “
DIGITAL OUT
”.
3
Press
OK
repeatedly to select the desired output (
PCM
or
BITSTREAM
), then press
SYSTEM MENU
.
BITSTREAM
–
To play DVDs, the digital audio output must be set to
BITSTREAM
for the DVD to use Dolby Digital or DTS
modes.
PCM
–
To record audio from the DVD system to an digital CD
recorder or other equipment, set the digital audio output
to
PCM
.
Note:
– To play audio CDs, you do not have to change BITSTREAM
to PCM. The DVD system makes the switch automatically.
P
REPARATIONS
