34
English
WARNING
Under no circumstances should you try to repair the system yourself, as this will
invalidate the warranty. Do not open the system as there is a risk of electric shock.
If a fault occurs, first check the points listed below before taking the system for repair. If
you are unable to remedy a problem by following these hints, consult your dealer or
PHILIPS for help.
Problem
Solution
Troubleshooting
Disc cannot play
No sound
No picture
Remote control does not work
✔
Make sure a disc is loaded.
✔
Make sure a disc is loaded with the label side up.
✔
Disc dirty or damaged. Clean the disc.
✔
Make sure the region code of the player is the
same as that of the DVD disc loaded.
✔
Moisture has condensed in the player. Remove
the disc and leave the player power-on until the
moisture evaporates.
✔
Check whether the set is connected securely.
✔
Make sure the set is not in the MUTE mode. If it
is, press MUTE to turn on the speaker.
✔
Check whether the volume on the set has been
set to the lowest level. If it has, turn up the
volume.
✔
Check whether the set is connected securely.
✔
First, select the source you wish to control by
pressing a source button (DVD, RADIO or TV
for example). Then, select the desired functions
(
í
,
ë
,
for example).
✔
Remove obstacles between the remote control
and the player, and point directly instead of at a
wide angle at the infrared sensor on the player.
✔
Make sure the battery has been inser ted
properly (check polarity).
✔
Battery maybe exhausted. Replace the battery
with a new one.
Radio reception is poor.
✔
If the signal is too weak, adjust the antenna or
connect an external antenna for better
reception.
✔
Increase the distance between the set and a TV,
VCR or radiation source.
The Clock setting is erased.
✔
Power has been interrupted or the power cord
has been disconnected. Reset the clock.
pg018-pg035_DCD778_37-EngB
9/2/07, 18:51
34
