84
Operator services
You may have up to five members at the same time
and end the conference with
)
. At this point all
calls are disconnected.
In order to make consecutive outgoing calls, first
initiate a normal call with the first number of the
conference. When the first member is on line, initiate
a second call as described in “Make a second call”
above. When the second call is engaged, press
,
and
select
Conference
. Repeat the above process until five
members are connected.
If there is an incoming call during the conference call
and there are less than five members, you can accept
this new call by pressing
,
. Press
,
again and then
select
Conference
to add this member to the
conference call. If there is an incoming call during a
conference with five members already connected, you
can answer this new incoming call, but not add it to
the conference.
While a conference call is in progress, press
,
to
access the
Conf. members
options. Disconnect a
member of the conference by selecting
Remove party
and pressing
,
to confirm, or select
Private call
to
have a private call with this member only (other
members are put on hold).
Subscription dependent
You can connect an active call and a call on hold. You
are disconnected when the transfer is completed.
During a call press
,
, select
Transfer
and press
,
.
This feature is different from the Call forward, which
takes place before you pick up the call (see page 72).
Explicit call transfer
Philips355_APMEA.book Page 84 Tuesday, November 16, 2004 2:36 PM
