Question
Answer
The shaving unit may be damaged or worn. Replace
the shaving unit (see chapter ‘Replacement’).
Why
doesn’t the
shaver work
when I press
the on/off
button?
The battery may be empty. Recharge the battery
(see chapter ‘Getting started’).
The travel lock may be activated. Deactivate the
travel lock (see chapter ‘Storage and transport’,
section ‘Transport’).
Dried shaving conditioner may block the shaving
heads in the shaving unit. Clean the shaver
thoroughly before you continue shaving (see chapter
‘Cleaning and maintenance’).
You may not have reassembled the shaving unit
properly after extra-thorough cleaning. When you
reassemble the shaving unit, make sure you turn each
guard anticlockwise until it locks into position.
Why does
little shaving
conditioner
come out of
the holes even
though there
is enough
conditioner in
the cartridge?
One of the conditioner holes may be blocked. Rinse
or soak the shaving unit. If this does not work, pump
shaving conditioner into the shaving conditioner
cartridge until conditioner starts to come out of the
blocked hole. If this does not work either, try the
following method: 1) Switch off the shaver 2) Pull the
shaving unit off the shaver 3) Put your finger on the
hole that is not blocked 4) Switch on the shaver 5)
Press the shaving conditioner button several seconds
until conditioner starts to come out of the blocked
hole again.
EngliSH
22
Summary of Contents for Coolskin HS8060
Page 1: ... 1 2 3 4 5 6 7 8 9 14 13 16 A B 15 12 17 11 10 1 ...
Page 2: ... ...
Page 161: ...2008 01 10 163 ...
Page 164: ...4222 002 4854 4 166 ...