ColorBurst 6 Product Guide
11
Included with the Mounting Base
Mounting Base with native 60 ft (18.3 m) power / data cable
Gasket
(4) M-4 screws with color-matched screw caps to attach
ColorBurst 6 Luminaire to the Mounting Base
(3) Snap-in stem bumpers for freestanding indoor installa-
tions
(3) Leg covers
Installation Instructions
5. Using the provided 8-32 screws for indoor installations, or the provided 10-24
stainless steel screws for outdoor installations, attach the Luminaire canopy to the
junction box. If using the junction box gasket, ensure that it is compressed evenly.
6. Cover the screw heads with the included color-matched screw caps.
7. Repeat steps 2 through 6 for each Luminaire in the installation.
8. If installing in a wet or damp location, seal all junction boxes with contractor-
grade RTV silicone sealant. Use gaskets, clamps, and other parts and fittings
required to comply with local outdoor wiring codes.
Mounting ColorBurst 6 to a Mounting Base
ColorBurst 6 Luminaires can be used freestanding with the Mounting Base, or they
can be mounted to a wall, ceiling, or other suitable surface. Snap-in stem bumpers
protect floors or other finished surfaces in freestanding indoor applications. The
native 18.3 m (60 ft) power/data cable is sealed to create a water-tight junction when
used with the included gasket.
1. Determine the Luminaire location as specified in the lighting design plan. Ensure
that the mounting location is free of debris, and that the Mounting Base sits flush
to the mounting surface.
2. If installing in a wet or damp location, run the wire leads from the ColoBurst 6
Luminaire through the included gasket.
3. Connect Luminaire wire leads to the Mounting Base leads using medium wire nuts.
Connect red to red, white to white, and black to black.
4. Insert the included M-4 screws through the Luminaire canopy and, if applicable,
the gasket, and into the Mounting Base. Tighten the screws. Cover the screw
heads with the included color-matched screw caps.
5. For freestanding applications, press the included snap-in stem bumpers into the
mounting holes on the bottom of each foot of the Mounting Base.
6. If mounting to a surface, insert #8 screws suitable for the mounting surface (not
included) through the holes in the bottom of each foot of the Mounting Base. Use
lock washers to prevent the screws for loosening.
7. Press the included leg covers into the opening on the top of each leg of the
Mounting Base for a clean, finished look.