Philips CEM5000, User Manual

Page: 13 / 31

14
Note
Skip this step if the unit is not fi xed by sleeve
•
but by supplied screws.
6
Place the supplied rubber cushion over
the end of the mounting bolt.
7
Slide the unit into the dashboard until you
hear a click sound.
8
Reconnect the negative terminal of the
car battery.
Attach the front panel
1
Attach the trim plate to the main unit.
2
Insert the right side of the panel in the
chassis until it is correctly engaged.
3
Push the left side of the panel and point
the left hole at the left pillar.
4
Release the panel to engage the left side.
5mm
If the car battery is not disconnected, •
to avoid short-circuit, ensure that
bare wires do not touch each other.
2
Remove the two screws on the top of the
unit.
3
Remove the mounting sleeve with the
supplied disassembly tools.
4
Ensure that car dashboard opening is
within these measurements:
1
83 mm
53mm
5mm
5
Install the sleeve into the dashboard and
bend the tabs outward to fi x the sleeve.
EN