Philips CE138, User Manual

Page: 9 / 30

7 EN
3 Install the car
audio system
Caution
.
Use the controls only as stated in this user manual.
Always follow the instructions in this chapter in
sequence.
These instructions are for a typical installation.
However, if your car has different requirements,
make the adjustment accordingly. If you have
any question regarding installation kits, consult
your local retailer.
Note
.
This system is designed for negative ground (earth) 12V
DC operation only.
.
Always install this system in the car dashboard. Other
locations can be dangerous as the rear of the system
heats up during use.
.
To avoid short-circuit: before you connect, make sure
that the ignition is off.
.
Make sure that you connect the yellow and red power
supply leads after all other leads are connected.
.
Make sure that all loose leads are insulated with
electrical tape.
.
Make sure that the leads do not get caught under
screws iron parts that will move (e.g. seat rail).
.
Make sure that all ground (earth) leads are run to a
common ground (earth) point.
.
Use only the supplied mounting hardware for a safe
and secure installation.
.
Q+5#"5'#$4,)')$123$12,)'$02+2:'$"#$(#'7$8&'3$9",$
need to change the fuse, consult a professional.
.
When you connect other devices to this system, make
sure that the rating of the car circuit is higher than the
total fuse value of all the connected devices.
.
Never connect speaker wires to the metal body or
chassis of the car.
.
Never connect speaker wires with stripes to one
another.
Connect wires
Note
.
Make sure that all loose leads are insulated with
electrical tape.
.
Consult a professional to connect wires as instructed below.
1
Check the car's wiring carefully and
connect them to the the supplied ISO
male connectors.
ISO male
connectors Connect to
a Green strip,
black-edged
green strip Rear left speaker
b White strip, black-
edged white strip Front left speaker
c Gray strip, black-
edged gray strip Front right speaker
d Purple strip, black-
edged purple strip Rear right speaker
e Red strip Ignition key +12V DC
when ON/ACC
f Blue strip Motor/electric antenna
relay control lead
g White-edged blue
strip K+56*('#$#'629$1"3%#"6$
lead
h Black strip Ground
i Yellow strip To the +12V car
battery which is
energized at all times