Philips CE132-G/all, Service Manual

Page: 13 / 14

13
Date
2012-4-10
NO.
3
NO
audio
output
4
5DGLR
DEQRUPDO
d. To check the oscillation frequence of crystal X131 of the tuner IC,shuold be 32.768MHz
b. To check whether the strength of then input signal of the tuner is too weak.
c. To check the voltage of the 12 pin
ǃ
13 pin of the U131 of the tuner IC, should be +3V3.
a. To check the antenna of the AM/FM tuner.
a. To check whether the volume knob is turn to the minimum position.
b. To check whether the unit is at MUTE mode, press SOURCE button and check whether it is effective of the input sound
source.
c. To check whether the connection of audio output wire of ISO connector is correct; wrong connection or short circuit to the
ground will caused the protection of the power amplifier( no voltage output).
e. To check the voltage of 22 PIN(MUTE) of power amplifier U501(7388 IC) , normally should be +4V0.
d . To check the circuit of power amplifier U501(7388 IC) and VOLUME U301(7313 IC).
a. To check whether the CN1(ISO) connector of the tail of the unit is connect well , Whether it is loose of the 15A fuse of the
ISO, or insert non in place.
7URXEOHVKRRWLQJ 7URXEOHVKRRWLQJ 7URXEOHVKRRWLQJ 7URXEOHVKRRWLQJ
failure
phenomena
failure cause remark
Product Model
CE132
$UHD $UHD $UHD $UHD $OODUHD
NO Power
1
b. To check whether there is any contamination and bad contact on the 22Pin male/female connector on the panel and main
board.
e. To check the oscillation frequence of crystal CF202 shuold be 12MHz .
d. At the unit ACC ON, To check the 32 pin voltage of the U201(MCU) should be low level .
LCD
abnormal
2
a.To check whether there is any contamination and bad contact on the 22Pin male/female connector on the panel and main
board.
c.To check the voltage of the L2 of the TFT board,should be +5V0.
b.To Check the voltage of the 56 pin of the IC901(75823) ,should be +5V0.
c. To check the U602 of voltage regulator IC,the output pin should be +5V0
ǃ
the input pin should be +12V0.
d.To check whether there is any contamination and bad contact on the male/female connector of the panel and main board. If
necessary, can exchange the panel to test whether the defective is occurred by the unit or panel.