11
EN
4 Get started
Caution
•
Use of controls or adjustments or performance of
procedures other than herein may result in hazardous
radiation exposure or other unsafe operation.
Know the LED indicator status
LED indicator in the button
Indicator
Status
(Solid)
In standby mode
(Off)
In operation or eco power
standby mode
LED indicator in the Bluetooth SETUP button
Indicator
Status
(Blinking)
Ready for Bluetooth pairing
(Solid)
Connected through Bluetooth
Set clock
Note
•
During setting, if no action is taken within 90 seconds,
the device exits clock setting without saving the
previous operations.
•
You can also enter the hour and minute digits with the
numeric keypad.
1
In normal standby mode, press
PROG/
CLOCK
to activate clock setting.
»
24HOUR
(24-hour time format) blinks.
2
Press
/
to select
24HOUR
or
12HOUR
(12-hour time format), and then
press
PROG/CLOCK
to confirm.
»
The hour digits blink.
»
If you select
12HOUR
as the time
format,
PM
or
AM
is displayed.
3
Press
/
repeatedly to set the
hour digits.
4
Press
PROG/CLOCK
to confirm.
»
The minute digits blink.
5
Press
/
repeatedly to set the
minute digits.
6
Press
PROG/CLOCK
to confirm the clock
setting.
»
The set clock is displayed.
Tip
•
You can also synchronize the system clock with an
RDS radio station that transmits time signals (see
'Synchronize clock with RDS' on page 15).
Turn on
•
Press .
»
The unit switches to the last selected
source.
Switch to standby mode
•
Press again to switch the unit to standby
mode.
»
The clock (if set) is displayed on the
panel.
To switch to ECO standby mode:
•
Press and hold for more than three
seconds.
»
The display panel is dimmed.
Note
•
The unit switches to Eco Power Standby mode after 15
minutes in standby mode.
To switch between standby mode and ECO
standby mode:
•
Press and hold for more than three
seconds.