STEP #3
WIRING THE EMERGENCY DRIVER
> Select the appropriate wiring diagram to connect the emergency driver to the AC driver and LED load.
Make sure all connections are in accordance with the National Electrical Code and any local regulations.
> After installation is complete, supply AC power to the emergency driver and join the converter connector.
> At this point, power should be connected to both the AC driver and the emergency driver, and the Charging
Indicator Light should illuminate indicating the battery is charging.
> A short-term discharge test may be conducted after the emergency driver has been charged for one hour. Charge
for 24 hours before conducting a long-term discharge test. Refer to OPERATION.
> In a readily visible location, attach the label
"CAUTION - This Unit Has More Than One Power Connection Point.
To Reduce The Risk Of Electric Shock, Disconnect Both The Branch Circuit-Breakers Or Fuses And Emergency
Power Supplies Before Servicing."
PUSH TO TEST
INSTALLING THE 2W-ITS ON A DRIVER CHANNEL COVER
> Drill or punch a 7/8 inch hole in the driver channel cover. Insert the large
flanged bushing included with the parts kit. Insert the plastic tube into the
large flanged bushing. Slide the 2W-ITS tube up or down to adjust the height
and visibility of the charging indicator light.
> Slide the plastic tube up or down to adjust the height and visibility of the
charging indicator light. If the tube is too long, cut the plastic tubing to
necessary length.
> After cutting the tube to the proper length, assemble the 2W-ITS.
To assemble the 2W-ITS Assembly:
• Feed the 2W-ITS leads through the plastic tubing.
• Insert the white bushing in the opposite end of tube from the 2W-ITS
body.
• Pull switch leads and use provided tie wrap to secure leads snug against
white bushing.
• Unscrew hex nut to apply tension to leads.
> Wire the test switch per wiring diagrams provided on these instructions.
> If wired correctly, the 2W-ITS indicator light should be ON when AC power
is supplied to the fixture, indicating that the emergency inverter battery is
charging. After installing, mark with the "PUSH TO TEST" and "CHARGING
INDICATOR LIGHT" labels.
STEP #2b
PUSH TO TEST
Plastic Tube
2 Wire Illuminated Test Switch
Tie Wrap
White
Bushing
2W-ITS
Assembly
Components
STEP #2a
INSTALLING THE 2W-ITS ON FIXTURE SURFACE
> Mount the supplied 2W-ITS (2 wire illuminated test switch) in a location that is
visible and accessible by maintenance personnel. The 2W-ITS mounts through a
½” hole which may need to be made in the luminaire or could come pre-punched
by the luminaire supplier.
> Wire the test switch per wiring diagrams provided on these instructions.
> If wired correctly, the 2W-ITS indicator light should be ON when AC power is
supplied to the fixture, indicating that the emergency inverter battery is
charging. After installing, mark with the "PUSH TO TEST" and "CHARGING
INDICATOR LIGHT" labels.
Hex Nut
2 Wire
Illuminated
Test Switch
Fixture or
Test/Monitor Plate
Drill or Punch
a 1/2” Hole
Violet
Brown
3
