8
EN
3
Close the battery compartment.
Note
•
If you are not going to use the remote control for a
long time, remove the batteries.
•
Do not use old and new or different types of batteries
in combination.
•
Batteries contain chemical substances, so they should
be disposed of properly.
Set clock
1
In standby mode, press and hold
PROG/
CLOCK SET
on the remote control for
3 seconds.
»
The 12 or 24
hour format is displayed.
2
Press / to select the 12 or 24 hour
format.
3
Press
PROG/CLOCK SET
to confirm.
»
The hour digits are displayed and begin
to blink.
4
Press / to select hour and press
PROG/CLOCK SET
to confirm.
»
The minute digits are displayed and
begin to blink.
5
Press / to select minute and press
PROG/CLOCK SET
to confirm.
Tip
•
In ECO mode or when the unit is switched on, you can
press
PROG/CLOCK SET
to view the set clock.
Turn on
• Press .
»
The unit switches to the last selected
source.
»
The signal strength indicators flash for
several seconds until the unit boots up.
Switch to standby mode
• Press again to switch the unit to standby
mode.
»
The clock (if set) is displayed on the
panel.
Switch to ECO mode:
• Press and hold for more than 3 seconds.
»
The display panel is dimmed.
Note
•
In single mode, the unit switches to ECO mode
automatically after 15 minutes of inactivity.
•
In group mode, the unit does not go to ECO mode
automatically.
To switch between standby
mode and ECO mode:
• Press and hold for more than 3 seconds.
Summary of Contents for BM90
Page 2: ......
