Repair Service Flow
How to replace the defective Blu-ray Loader
1.Remove the defective Blu-ray Loader.
4. Remove soldered joint on the ESD protection points.
Note:The ESD protection points on any one side must be soldered if
a.The Blu-ray Loader needs to be disconnected from connector HA1,HA2 and HA3 of
the BD Board.
b.The defective Blu-ray Loader is needed to be send back to supplier for failure analysis and
to support backcharging evidence.
2.Remove the shield cover at the top of Blu-ray Loader as shown below:
3.Assembly Blu-ray Loader to “HA1,HA2,HA3” on the top of BD Board as shown below:
HA1
HA2
HA3
The ESD protection
points on the top of board.
Top Side
Bottom Side
The ESD protection points
on the bottom of board.
12-1
Summary of Contents for BDP9600/51
