User Manual BDL4635E
13
To avoid monitor from falling
Take measures to prevent the monitor from falling over in case of an earthquake or other disaster might occur to lessen the probability of injury and
damage.
As shown in the figure below, secure the monitor to a solid wall or pillar using rope (commercially available) strong enough to bear the weight of the
monitor(BDL4635E: approx. 34.6 kg). Screw hooks (commercially available), of ring type rather than C-shaped screw hooks (with opening), are
recommended.
Caution:
Though the recommended prevention from falling is intended to lessen the probability of injury and damage, it doesn’t assure its effectiveness
against any kind of earthquake or disaster.
Before moving the monitor, remove the rope that is securing the monitor.
Method II: Mount the monitor on the wall
Before mounting the monitor to the wall, make sure that the system has been power-off and you have obtain a standard wall-mounting kit
(commercially available). Using mounting interface that comply with TÜV-GS and/or UL1678 standard in North America is recommended.
Tabletop stand
1. Lay a protective sheet on a table, which was wrapped around the monitor when it was packaged, beneath the surface as not to scratch the
screen face.
2. This device cannot be installed without the correct and complete mounting accessories (not provided in the box). Make sure you have all related
parts available for wall mounting.
3. Follow the instructions that come with the base mounting kit. Failure to follow correct mounting procedures could result in damage to the
equipment or injury to the user or installer. Product warranty does not cover damage caused by improper installation.
4. For the wall-mounting kit, use M6 mounting screws (having a length 10 mm longer than the thickness of the mounting bracket) and tighten them
securely. (Recommended torque: 470 - 635N•cm).
Caution:
For preventing the monitor from falling.
Install the monitor with metal brackets for wall or ceiling installation (commercially available) on your own responsibility. For detailed procedures of
installation, refer to the instructions of the metal brackets.
To lessen the probability of injury and damage resulting from fall of the monitor in case of earthquake or other disaster, be sure to consult the
bracket manufacturer for installation location.
To lessen the risk of falling of the monitor, thread commercially available rope (having a load capacity at least 1960N (200kgf)) through the handles
at the right and left of the monitor and secure the rope to the wall mount brackets or ceiling mount brackets.(Refer to the first paragraph of this
page.)
Protective
Sheet
Table
Handles
Screw
Holes
Screw
hook
Clamper
Screw
Rope
*
Clamper
and
Screw
here
is
not
supplied
.