Philips AVENT Premium Plus, Manual

Page: 26 / 78

26 English
Emissions Compliance Electromagnetic environment – guidance
RF emissions
CISPR 11 Class B The device is suitable for use in locations in
residential environments and in establishments
directly connected to a low voltage power supply
network which supplies buildings used for domestic
purposes.
Harmonic emissions
IEC 61000-3-2 Complies
Class A Category
Voltage fluctuations / flicker
emissions IEC 61000-3-3 Complies
Guidance and manufacturer's declaration – electromagnetic immunity
The Philips Avent single/double electric breast pump Premium Plus is intended for use in the electromagnetic
environment listed below. The user of the device should ensure that it is used in such an environment to prevent
improper operation.
Immunity test Immunity test level Electromagnetic environment - guidance
Electrostatic discharge (ESD)
IEC 61000-4-2 ±8 kV contact
±15 kV air Floors can be a source of static electricity. When the air
is very dry (<20 % RH) the user is advised to prefer to
use the device in a room with concrete or wooden floors
(instead of using it in a room with a synthetic floor).
Radiated RF EM fields
IEC 61000-4-3 10 V/m
80 MHz – 2.7 GHz
80 % AM at 1 kHz
Proximity fields from RF
wireless communications
equipment
IEC 61000-4-3 385 (27), 450 (28), 710 (9), 745
(9), 780 (9), 810 (28), 870 (28),
930 (28), 1720 (28), 1845 (28),
1970 (28), 2450 (28), 5240 (9),
5500 (9), 5785 (9) MHz (V/m) The device is immune against any RF wireless
communication device such as smart phone, Wi-Fi
or Bluetooth device at a distance of 30 cm or more.
Avoid a closer distance as this may result in improper
operation.
Rated power
frequencymagnetic fields
IEC 61000-4-8 30 A/m
50 Hz or 60 Hz
Electrical fast transient/ burst
IEC 61000-4-4 ±2 kV
100 kHz repetition frequency Mains power quality expected of a typical commercial
or residential environment.
Surges
IEC 61000-4-5 ±1 kV Line-to-line
±2 kV Line-to-ground Mains power quality expected of a typical commercial
or residential environment.
Conducted disturbances
induced by RF fields
IEC 61000-4-6 3 Vrms, before modulation is
applied
0.15 MHz – 80 MHz
6 Vrms, before modulation is
applied, in ISM and amateur
radio bands between 0.15 MHz
and 80 MHz
80 % AM at 1 kHz
Voltage dips, short
interruptions and voltage
variations on power supply
input lines
IEC 61000-4-11 0 % UT; 0.5 cycle at 0°, 45°,
90°, 135°, 180°, 225°, 270°and 315°
0 % UT; 1 cycle and 70 % UT;
25/30 cycles single phase at 0°
0 % UT; 250/300 cycle Mains power quality expected of a typical commercial
or residential environment. At power interruptions the
breast pump will automatically switch-over to battery
mode without interruption of the function.