Power Supply
General Operation/ Radio
Using AC power
1
Check if the power voltage,
as shown on
the type plate located on the
bottom of the set
, corresponds to your
local power supply. If it does not, consult
your dealer or service center.
2
If your set is equipped with a voltage
selector, adjust the selector so that it
matches with the local mains.
3
Connect the power cord to the
AC
INPUT
inlet and the wall socket.The power
cord is now connected and ready for use.
4
To switch the set off completely, withdraw
the power cord from the wall socket.
5
Install the unit near the AC outlet and where
the AC power plug can be easily reached.
•
Disconnect the mains lead from the wall
socket to protect your set during heavy
thunderstorms. Children could seriously
injure themselves as the free end of the
cable may still be live if only the connector is
removed from the MAINS socket at the back
of the unit.
Helpful hints :
To avoid unnecessary energy
consumption, always adjust the
Source
selector
to
TAPE
(
OFF
) after using the
set. Also check that the tape deck keys are
released.
The type plate is located on the bottom
of the set.
General operation
Switching on and off and selecting
functions
1
To switch on, push the
Source selector
slider to
TAPE
or
RADIO
as desired.
2
To switch off, push the
Source selector
to
TAPE/OFF
and check the cassette keys
are released.
Helpful hints:
–
To change from
TAPE
to
RADIO
, or when
you are switching off the set: first make sure you
press the
STOP
•
EJECT
9/
key to end
playback and all the cassette keys are released.
Adjusting volume
•
Adjust the volume with the
VOLUME
control.
Radio reception
1
Adjust the
Source selector
to
RADIO
.
2
Adjust the
Band selector
to select your
desired waveband,
MW
,
SW1
,
SW2
or
FM
.
3
Turn
TUNING
to tune to a station.
-
FM STEREO
lights up when receiving
stereo FM reception.
- When receiving
SW
, you may also use
FINE TUNING rotary
to fine tune to a
station.
4
To switch off the radio, adjust the
Source
selector
to
TAPE
(
OFF
) position.
To improve radio reception:
•
For
FM
,
SW2
, extend and turn the tele-
scopic antenna for best reception. Reduce its
length if the signal is too strong.
•
For
MW
,
SW1
, the set uses a built-in
antenna. Direct this antenna for best recep-
tion by turning the whole set.
