17
English
WARNING
Under no circumstances should you try to repair the system yourself, as this will
invalidate the warranty. Do not open the system as there is a risk of electric shock.
If a fault occurs, first check the points listed below before taking the system for repair. If
you are unable to remedy a problem by following these hints, consult your dealer or
PHILIPS for help.
Problem
Solution
Troubleshooting
nocd
or
E
rr
indication
No sound
The system does not react when buttons
are pressed.
Remote control does not work
✔
No disc inser ted. Insert a suitable disc
✔
Replace/clean CD
✔
CD-R(W) is blank or the disc is not finalized.
Use a finalized CD-R(W)
✔
Moisture has condensed in the player. Remove
the disc and leave the player power-on until the
moisture evaporates.
✔
Check whether the set is connected securely.
✔
Make sure the set is not in the MUTE mode. If it
is, press MUTE to turn on the speaker.
✔
Check whether the volume on the set has been
set to the lowest level. If it has, turn up the
volume.
✔
CD-ROM disc inserted/CD contains non-audio
files. Use CD Audio discs only.
✔
Remove and reconnect the AC power plug and
switch on the system again.
✔
Remove the protective plastic tab before using
the remote control.
✔
Reduce the distance between the remote
control and the set.
✔
Replace the battery.
✔
Point the remote control directly towards the IR
sensor.
Radio reception is poor
✔
If the signal is too weak, adjust the antenna or
connect an external antenna for better
reception.
✔
Increase the distance between the set and a TV,
VCR or radiation source.
The Clock setting is erased
✔
Power has been interrupted or the power cord
has been disconnected. Reset the clock.
p001-p018_AJ6110_37-Eng
2008.10.16, 10:53
17
