6
English
ILLUMINATION BRIGHTNESS
Press
REPEAT ALARM/
BRIGHTNESS CONTROL
once or more.
™
The brightness of the display will change in this sequence:
BRIGHT
➟
DIM
➟
BRIGHT...
Note:
When an alarm or the
SLEEP
function is active, brightness
cannot be adjusted.
SETTING THE CLOCK
The time is displayed using the 24 hour clock.
1.
Press
TIME SET
for more than 2 seconds to enter time
setting mode.
™
Time displays and flash.
2.
Press
HR
or
MIN
repeatedly or hold down on the button to
adjust the hours and minutes respectively. Release
HR
or
MIN
when you reach the correct setting.
3.
After you have set both the hours and minutes,
press
TIME SET
to confirm the correct setting.
™
Clock time also starts to run automatically after
60 seconds after you adjust the time.
Note:
Press
ALARM SET
during time setting will switch to alarm
setting mode.
RADIO
1.
Press
SLEEP / RADIO ON
once to switch on the radio.
2.
Select your waveband using the
BAND
switch.
3.
Use
TUNING
to find your radio station.
4.
Adjust the sound using
VOLUME
.
5.
Press
ALARM RESET / RADIO OFF
to switch off.
To improve reception:
FM:
extend and position the pigtail aerial to obtain optimum
reception.
MW (or LW):
uses a built-in antenna inside the set. Direct
the antenna by adjusting the position of your set.
SETTING THE ALARM
General
If you wish to use the alarm, first set the alarm time.
There is a choice of two alarm modes, buzzer or radio. The
alarm display shows the alarm time all the time and the alarm
indicator appears if the alarm is set.
BASIC FEATURES
XP AJ3010/00 20-06-2000 16:33 Pagina 6
