Philips A10E, Service Information

Page: 2 / 22

EN 2 A10E AA 02.01
Warnings
• Non mains-isolated (=hot) parts:
On the Power Supply of the Digital Board, 2 areas are not isolated
from the mains. See grey parts in figure 1.
Figure 1
Mechanical Instructions
Note: Figures can deviate slightly from the actual situation, due to
different set executions.
Removing the Digital TV module
1.
Before you can access the Digital TV module, remove the rear
cover.
2. Disconnect all cables on the Digital TV module.
3. Take the module out of the set.
Removing the Digital Board from the bracket (see fig. 2)
1.
Remove the I/O cover plate by lifting the upper and lower snap
hooks [1]. Then remove the cover plate [2].
2. Now the complete Digital Board PWB can be slid out of its bracket
[3]. If the board blocks, it is possible due to connector 1000, which
can hamper the movement of the panel. Press the board a little
upward near this connector and slide it out.
Figure 2
CL 06532106_004.eps
010800
POWER SUPPLY
DIGITAL BOARD
"HOT" PART
CL 06532106_007.eps
030800
4
3
2
1
1