LightPack LED Module
Installation & Operation Guide
7
SETTING MODES AND DMX512 ADDRESS
The operating modes and DMX512 address can be easily configured using the controls located
inside the recess panel. There is one 4-position DIP switch (Configuration Switch) to
configure the modes and three rotary DIP switches to configure the DMX512 address.
For example (as shown in
Figure 7
), to set a DMX512 address of 471, set the 100’s dial to "4",
the 10’s dial to "7", and the 1’s dial to "1". To configure the modes, set each of the DIP
switches to either the ON or OFF setting (up or down).
Figure 7: DIP Switches
To program individual DMX512 address, 8/16 Bit Mode, and Intensity Channel for each
connected luminaire:
Step
1. At Configuration Switch, set Switch 4 to “ON”.
Step
2. At Configuration Switch, set 8 /16 Bit Mode and Intensity channel switches as
desired.
Step
3. Set each DMX address dial to desired DMX512 address for first luminaire.
Step
4. Press and hold Focus / Bump button until first luminaire flashes.
Step
5. Set each DMX address dial to desired DMX512 address for second luminaire.
Step
6. Press and hold Focus / Bump button until second luminaire flashes (about 5
seconds).
Step
7. When programming is complete, at Configuration Switch, set Switch 4 to “OFF”.
Configuration Switch
ON = Program On
OFF = Program Off
For Future Use
ON = Intensity Channel On
OFF = Intensity Channel Off
ON = 16-Bit Mode
OFF = 8-Bit Mode
DMX512 Address Switches
000 = DMX Disabled (only
Focus / Bump Button active)
001 - 512 = DMX512 Address
