SAVE THESE INSTRUCTIONS
Item #750403, 752803
051 01 0078, 051 01 1078
Page 3 of 5
ASSEMBLY INSTRUCTIONS
WARNING:
Risk of personal injury and electric shock: Watch for any bulbs that may have broken during
shipping and replace following the bulb replacement instructions before plugging in or assembling.
1.
Carefully remove all pieces from the box and lay out parts flat on the floor. Carefully remove all
protective wrapping from the parts, paying special attention to avoid cutting or damaging the parts.
Before beginning tree assembly please make sure all carton contents are present. A complete listing
and diagram of contents are listed on page 1. Do not attempt to assemble the tree if any parts are
missing or damaged. Please contact our customer service department for replacement parts
–
DO NOT RETURN TO PLACE OF PURCHASE.
2. Take the Tree Stand (D) out and lay the stand in a flat area. Then slide
the locking disk downward and snap into place.
3. Remove the plastic pole protectors from the end of each tree
section before assembling and discard.
See Figure 1
4. Insert Bottom Section of tree (C) into the assembled Tree Stand (D). Make sure
the pole is firmly inserted into the stand.
Locate the round female connector from
Bottom Section of tree (C) and place it near the top of Bottom Section (C) by the
center pole.
See Figure 2
for image of connectors.
5. Insert Middle Section of tree (B) into the Bottom Section of tree (C). Connect the male connector
from Middle Section of tree (B) into the female connector from Bottom Section of tree (C). Secure the
connection by twisting the round cap into place. Locate the female plug from Middle
Section of tree (B) and place it near the top of Middle Section (B) by the center pole.
6. Insert the Top Section of tree (A) into Middle Section of tree (B).
Connect the male connector from Top Section of tree (A) into the female connector
from Middle Section of tree (B). Secure the connection by twisting the round cap into place.
Locate the male connector from the bottom of Bottom Section of tree (C) and connect it to the female
connector of the control box (E). Secure the connection by twisting the round cap into place. Plug the
cord from the control box into the wall outlet. The entire tree should now be lit and is pre-set to light
function 10: Bi-Directional Chasing Multicolors.
Refer to the Illuminate
TM
instructions from the Quick Start
Guide on how to set-up Wi-Fi and use the app to control your tree lights.
7. Allow branches to fall into place or gently pull up and out. Please note that the Top Section (A) does
not have hinges like the Middle Section (B) and Bottom Section (C).
8. Begin to shape the branches working from the bottom of the tree to the top. Start with the tips closest to
the tree’s center pole. Fan out branch tips, one to the right, one to the left and one at the center. Tips
should be alternately placed so that they do not line up one after another. For further shaping
instruction, please see diagram below or go to our website at www.seasonalspecialties.com.
Before beginning tree assembly please make sure all carton contents are present. Do not attempt to
assemble the tree if any parts are missing or damaged. Please contact our customer service
department if you need any assistance or replacement parts:
1-800-763-6177
, 8:30 a.m. – 5:00 p.m. CST,
Monday – Friday or visit our website at
www.seasonalspecialties.com
.
D
Fig. 1
Fig. 2
