6.4
Pairing with TV
This remote control uses radio frequency (RF) to send
its commands to the TV. Unlike remote controls using
infrared signals, with this remote control you can send
commands without pointing at the TV.
The TV will notify you when the battery power of the
remote control is low.
Pairing the remote control
For the remote control to communicate with the TV,
both TV and remote control should be paired with
each other. Once paired, you cannot use the remote
control to control another TV.
When you started the initial TV installation, the TV
asked you to press the
OK
key, and by doing so, the
pairing was done. When you turn off the TV, the
pairing is stored. You can pair up to 5 remote controls
with this TV.
Pairing again
You can pair another remote control with this TV.
The method to pair a remote control is different for a
remote control already paired with another TV
compared with a remote control that is not paired yet.
•
The remote control is paired with another TV
To pair, hold the remote control close to the TV and
press the
Red and
Blue key at the same time
for 5 seconds. A message will appear if pairing is
successful.
•
The remote control is not paired yet
To pair, hold the remote control close to the TV and
press
OK
for a few seconds. A message will appear if
pairing is successful.
For retail
To pair a new, not yet paired TV with a remote control
that is already paired with another TV, hold the
remote control close to the TV and press the
Red
and
Blue key at the same time for 5 seconds. A
message will appear if pairing is successful.
Note:
If the remote control still fails to pair with the TV,
press
>
Setup
>
TV settings
>
General settings
>
Reinstall TV
, then repeat the pairing step.
6.5
Batteries
If the TV does not react on a key press on the remote
control, the batteries might be empty.
To replace the batteries, open the battery
compartment on the keyboard side of the remote
control.
1 -
Slide the battery door in the direction shown by
the arrow.
2 -
Replace the old batteries with 2 type
AAA-
LR03-1.5V
alkaline batteries. Make sure the + and the
- ends of the batteries line up correctly.
3 -
Reposition the battery door and slide it back until
it clicks.
Remove the batteries if you are not using the remote
control for a long time.
Safely dispose of your old batteries according to the
end of use directions.
For more information, press
Keywords
and look
up
End of use
.
6.6
Cleaning
Your remote control is treated with a scratch-resistant
coating.
To clean the remote control, use a soft damp cloth.
Never use substances such as alcohol, chemicals or
household cleaners on the remote control.
23
