Depart. Technical support- CM640
PROCEDURE COMPANY
RESTRICTED
PHILIPS Consumer
Communications
Centre du Mans
Service Repair Support
VY-V-640-P530
Page : 26 of 64
Langue : EN
Date : 21/07/03
8.3
Battery Charging (IGN : Ignition) / Current consumption
.3.1 Charger detection / Battery charging
- Plug the transformer unit into an ea
- Insert the Test production
ded (see picture) for
current measurement.
- Plug the connector of the charger (Basic Switch Mode Charger euro 2003 with Jack Con4.2V 0.30A max.)
into the right socket at the base of the transceiver. The battery symbol should indicate the state of charge :
•
Bars moving
- means the battery is being charged.
•
Steady
- means the battery is fully charged.
If the battery is totally discharged, the battery icon will start scrolling 2 to 3 minutes only after being connected to
charger.
Just after charger plugging a pre-charge current
30 < I (mA) < 70
can be observed during 2 or 3 seconds
After few seconds a charge current of
180 mA
approx. has to be observed
- Unplug the charger
8
sily accessible AC power socket.
Card in the mobile, plug a
+ -
dummy Battery with a multimeter ad
BAT -
BAT
A
+
PHILIPS ELECTRONICS N.V. 1999
VY-V-640-P530
All rights reserved. Reproduction in whole
or in part is prohibited without the written
consent of the copyright owner.