BDS
Mirror TV Application Note
Release v0.5
6.2
Mirror TV – Main Power Button
The main power button of the Mirror TV is located differently as compared to the
conventional 32”- 42” LCD TV. It is located on the side of the back plate of the
Mirror TV. Refer to the following picture:
M
M
a
a
i
i
n
n
P
P
o
o
w
w
e
e
r
r
B
B
u
u
t
t
t
t
o
o
n
n
Important points to observe when operating the Mirror TV that is in-wall mounted
If the Mirror TV is mounted into a wall recess, the main power button may not be
easily accessible. In such a scenario, it is advised that:
•
All connections and fine-tuning of TV settings be completed before the Mirror
TV is mounted into the wall recess.
•
This means that the Mirror TV should be connected to the power mains, and
switched on using the Main Power button. With the Mirror TV switched on,
configure the required TV settings.
•
After the settings have been configured, do NOT switch off the Mirror TV via
the Main Power button. Instead, set the Mirror TV to ‘standby’ mode via the
Remote Control unit
•
When the Mirror TV is now powered down in ‘standby’ mode, turn off the
power mains. Disconnect the Mirror TV from the power mains, and proceed to
mount the Mirror TV.
•
Once the Mirror TV is mounted properly, reconnect the power mains and turn
on the power mains switch. The Mirror TV should be in ‘standby’ mode.
•
To turn on the Mirror TV, use the Remote Control to wake the Mirror TV
from ‘standby’ mode. Subsequent control of the Mirror TV (including switching
on/off) should be via the Remote Control.
Copyright © Philips BDS-ITV 2005
12
