Mechanical Instructions
4.
4.11.5 Speakers
1.
Unplug the speaker connectors from the SSB.
2.
Remove all the fixation screws that secure the speakers.
3.
Gently release the tapes that secures the speaker cables.
4.
Take the speakers out.
When defective, replace the both units.
4.11.6 Stand bracket
1.
Remove all fixation screws of the bracket.
2.
Lift the bracket from the set.
4.11.7 Keyboard Control unit
1.
Unplug the connector from the SSB.
2.
Remove the fixation screw that secure the keyboard
control panel.
3.
Unplug the connector from the keyboard control panel.
4.
Gently release the tapes taht secures the keyboard cables.
5.
Take the keyboard out.
When defective, replace the whole unit.
4.11.8 IR/LED Panel
1.
Remove the stand bracket, as described earlier.
2.
Remove fixation screw that secure the deco rear cover and
take it out from the deco.
3.
Unplug the connector from the IR/LED panel.
4.
Gently release the double faced adhesive tape that pasted
the panel and take it out from the deco.
When defective, replace the whole unit.
4.11.9 WIFI module
1.
Unplug the connector from the SSB.
2.
Remove fixation screw that secure the WIFI module,
getntly remove the module from the set.
When defective, replace the whole unit.
4.11.10 LCD Panel
1.
Unplug all the connector cables of the boards.
2.
Lift the subframe with SSB, PSU, IR/LED board and WIFI
module panel from the LCD panel and put it aside.
3.
Gently take all the speakers out.
Warning:Cause the panels of 55" 5600 series are bolt-on
panels, the panel could not release from bezel.
When defective, replace the whole unit.
4.12 Set Re-assembly
To re-assemble the whole set, execute all processes in reverse
order.
Notes:
•
While re-assembling, make sure that all cables are placed
and connected in their original position. See
and
.
•
Pay special attention not to damage the EMC foams on the
SSB shields. Ensure that EMC foams are mounted
correctly.
