Mechanical Instructions
4.
4.3.5
Speakers
1.
Gently release the tapes that secures the speaker cables.
2.
Unplug the speaker connectors from the SSB.
3.
Take the speakers out.
When defective, replace the both units.
4.3.6
Stand bracket
1.
Remove all fixation screws of the bracket.
2.
Lift the bracket from the set.
4.3.7
IR/LED Panel
1.
Remove the stand bracket, as described earlier.
2.
Remove fixation screw that secure the deco rear cover and
take it out from the deco.
3.
Unplug the connector from the IR/LED panel.
4.
Gently release the double faced adhesive tape that pasted
the panel and take it out from the deco.
When defective, replace the whole unit.
4.3.8
WIFI module
1.
Unplug the connector from the SSB.
2.
Remove fixation screw that secure the WIFI module,
getntly remove the module from the set.
When defective, replace the whole unit.
4.3.9
LCD Panel
1.
Unplug all the connector cables of the boards.
2.
Lift the subframe with SSB, PSU, IR/LED board and WIFI
module panel from the LCD panel and put it aside.
3.
Gently take all the speakers out.
Warning:Cause the panels of 32"/48" 5500 series & 42"/47"
6100/6500 series are bolt-on panels, the panel could not
release from bezel.
When defective, replace the whole unit.
4.4
Assembly/Panel Removal ( for 24" 5600 series)
Instructions below apply to the 24PHK5619/12.
4.4.1
Rear Cover
Refer to
Warning: Disconnect the mains power cord before removing
the rear cover.
1.
Remove fixation screws [2] that secure the base assy, pull
out the base assy from the set. Then remove the fixation
screws [1] that secure the rear cover. Refer to
for details.
2.
At the indicated areas [3] the cover is secured by clips. Be
very careful with releasing those.
3.
Gently lift the rear cover from the TV. Unplug the connector
[1] from the SSB. Make sure that wires and cables are not
damaged while lifting the rear cover from the set. Refer to
Figure 4-23 Rear cover removal [1]
19603_105.eps
1
Q3 × 6
M4 × 16
1
2
2
2
3
3
