6.4
Pairing with TV
This remote control uses radio frequency (RF) to send its
commands to the TV. Unlike remote controls using infrared
signals, with this remote control you can send commands
without pointing at the TV.
The TV will notify you when the battery power of the remote
control is low.
Pairing the remote control
For the remote control to communicate with the TV, both TV
and remote control should be paired with each other. Once
paired, you cannot use the remote control to control another
TV.
When you started the initial TV installation, the TV asked you to
press the
OK
key, and by doing so, the pairing was done. When
you turn off the TV, the pairing is stored. You can pair up to 5
remote controls with this TV.
Pairing again
You can pair another remote control with this TV.
The method to pair a remote control is different for a remote
control already paired with another TV compared with a remote
control that is not paired yet.
•
The remote control is paired with another TV
To pair, hold the remote control close to the Philips logo (about
4 in) and press the
Red and
Blue key at the same time. A
message will appear if pairing is successful.
•
The remote control is not paired yet
To pair, hold the remote control close to the Philips logo (about
4 in) and press
OK
. A message will appear if pairing is successful.
For retail
To pair a new — not yet paired — TV with a remote control
which is already paired with another TV, hold the remote
control close to the Philips logo (about 4 in) and press the
Red and
Blue key at the same time. A message will appear if
pairing is successful.
Note:
If the remote control is still fail to pair the TV,
press
>
Setup
>
TV settings
>
General settings
>
Reinstall
TV
, then repeat pairing step again.
6.5
Batteries
If the TV does not react on a key press on the remote control,
the batteries might be empty.
To replace the batteries, open the battery compartment on the
keyboard side of the remote control.
1 -
Slide the battery door in the direction shown by the arrow.
2 -
Replace the old batteries with 2 type
AAA-LR03-1.5V
alkaline batteries. Make sure the + and the - ends of the
batteries line up correctly.
3 -
Reposition the battery door and slide it back until it clicks.
Remove the batteries if you are not using the remote control for
a long time.
Safely dispose of your old batteries according to the end of use
directions.
For more information, press
Keywords
and look up
End of
use
.
6.6
Cleaning
Your remote control is treated with a scratch-resistant coating.
To clean the remote control, use a soft damp cloth. Never use
substances such as alcohol, chemicals or household cleaners on
the remote control.
22
