Philips 40HFL4683S, Quick Start Setup Manual

Page: 7 / 12

7
Channel installation
This section describes how to install the TV channels
automatically.
1
Connect the RF signal to the TV.
2
Plug the power cord into the power outlet.
Cable
ANT. IN
3
Turn the TV on.
•
Press
.
POWER
at the
R
side of the TV or use the
.
(
POWER)
on the remote control.
4
Press
RC5 SETUP
to put the remote control into setup
P
mode, then press the
HOME/MENU
button to display
the setup menu. (Hereafter,
HOME/MENU
will be
simply referred to as
MENU
)
5
Select Consumer TV setup - Setup - Autoprogram ;
then select Cable. (unless the installation is using only
Antenna signals - in which case you would select
Antenna)
Note
•
The TV will not tune any channel that has not been fi rst
“installed”. This includes SPI direct tune commands!