Mechanical Instructions
4.
Figure 4-3 Rear cover removal
4.3.3
Keyboard Control unit
Refer to
for details.
Caution: Keyboard catch on the Back cover,must be carefull
the Keyboard cable connected from the SSB while opening of
Back cover.
1.
Remove the fixation screws [1] secure the keyboard control
panel from the Back cover.
2.
Gently release the connector [2] that connect the keyboard
cable from SSB.
3.
Gently take the keyboard out.
When defective, replace the whole unit.
Figure 4-4 Keyboard removal
4.3.4
Small Signal Board (SSB)
Caution: it is mandatory to remount all different screws at their
original position during re-assembly. Failure to do so may result
in damaging the SSB.
1.
Release the clips from the LVDS connector [1] that connect
with the SSB.
Caution: be careful, as these are very fragile connectors!
2.
Unplug all other connectors [2].
3.
Remove all the fixation screws [3] from the SSB.
4.
The SSB can now be shifted from side connector cover,
then lifted and taken out of the I/O bracket. Refer to
Figure 4-5 SSB removal
20080_102.eps
1
M3 × 6
1
1
2
2
1
M3 × 6
1
1
1
1
1
1
1
1
1
20080_104.eps
1
1
2
20080_103.eps
1
3
3
3
3
2
2
2
2