Philips 32HFL5009D/12, Service Manual, Page: 22 / 115

Mechanical Instructions EN 22 TPM14.1HE LA 4.
2014-May-16
back to
div. table
4.6.4 Speakers
1. Gently release the tapes that secures the speaker cables.
2. Unplug the speaker connectors from the SSB.
3. Take the speakers out.
When defective, replace the both units.
4.6.5 Stand bracket
1. Remove all fixation screws of the bracket.
2. Lift the bracket from the set.
4.6.6 IR/LED Board
1. Unplug the connector from the IR/LED board.
2. Gently release the clip that holds the board and take it out
from the bezel.
When defective, replace the whole unit.
4.6.7 LCD Panel
1. Unplug all the connector cables of the boards.
2. Lift the subframe with SSB, PSU, IR/LED board from the
LCD panel and put it aside.
3. Gently take all the speakers out.
Warning:Cause the panels of 40" 3009D series are bolt-on
panels, the panel could not release from bezel.
When defective, replace the whole unit.
4.7 Assembly/Panel Removal( for 40"/55" 5009D
series)
Instructions below apply to the 40HFL5009D/12, but will be
similiar to the other 40"/55" 5009D series models.
4.7.1 Rear Cover
Refer to Figure 4-18 for details.
Warning: Disconnect the mains power cord before removing
the rear cover.
1.
Remove fixation screws [1] that secure the base assy, pull
out the base assy from the set. Then remove the fixation
screws [2], [3] that secure the rear cover. Refer to
Figure 4-18 for details.
2. Gently lift the rear cover from the TV. Make sure that wires
and cables are not damaged while lifting the rear cover
from the set.
Figure 4-18 Rear cover removal
19680_117.eps
1
M4 × 10
Q3 × 8
1 1
1
1
3
2
2
2
2
2
2
2
2 2
2
2
2
2
2
2
M3 × 4
3