Philips 32HFL5009D/12, Service Manual, Page: 17 / 115

Mechanical Instructions EN 17 TPM14.1HE LA 4.
2014-May-16
back to
div. table
Figure 4-11 SSB removal
4.3.3 Power Supply Unit (PSU)
Caution: it is mandatory to remount all different screws at their
original position during re-assembly. Failure to do so may result
in damaging the PSU.
1.
Gently unplug all connectors from the PSU.
2. Remove all fixation screws from the PSU.
3. The PSU can be taken out of the set now.
4.3.4 Speakers
1. Gently release the tapes that secures the speaker cables.
2. Unplug the speaker connectors from the SSB.
3. Take the speakers out.
When defective, replace the both units.
4.3.5 Stand bracket
1. Remove all fixation screws of the bracket.
2. Lift the bracket from the set.
4.3.6 IR/LED Board
1. Unplug the connector from the IR/LED board.
2. Gently release the clip that holds the board and take it out
from the bezel.
When defective, replace the whole unit.
4.3.7 LCD Panel
1. Remove the stand as described earlier
2. Remove the SSB as described earlier.
3. Remove the PSU as described earlier.
4. Remove the speakers as described earlier.
5. Remove the IR/LED board as described earlier.
6. Remove all other metal parts that do not belong to the LCD
panel.
7. Release all fixing clips that secure the front bezel to the
LCD panel.
8. Lift the LCD Panel from the front bezel.
When defective, replace the whole unit.
4.4 Assembly/Panel Removal( for 28" 5009D
series)
Instructions below apply to the 28HFL5009D/12.
4.4.1 Rear Cover
Refer to Figure 4-12 for details.
Warning: Disconnect the mains power cord before removing
the rear cover.
1.
Remove fixation screws [1] that secure the base assy, pull
out the base assy from the set. Then remove the fixation
screws [2], [3] that secure the rear cover. Refer to
Figure 4-12 for details.
2. Gently lift the rear cover from the TV. Make sure that wires
and cables are not damaged while lifting the rear cover
from the set.
19680_110.eps
2
3
1
4
4
4
4