35
9. Feature settings
[Multi RC]
This function allows that up to four televisions can be installed in a room whereas every TV will listen to its own RC.
Once the TV is set, also every RC can be set to remember its connected TV:
[Off]
Multi RC is turned off; all TVs will listen to a ‘blue’ RC.
The TV will listen to a ‘blue’ RC. Press and hold both the menu and blue button on the RC for about five
seconds to change the color of the remote.
[Green]
The TV will listen to a ‘green’ RC. Press and hold both the menu and green button on the RC for
about five seconds to change the color of the remote.
[Yellow]
The TV will listen to a ‘yellow’ RC. Press and hold both the menu and yellow button on the RC for
about five seconds to change the color of the remote.
[Red]
The TV will listen to a ‘red’ RC. Press and hold both the menu and red button on the RC for about five
seconds to change the color of the remote.
[Digit 0]
The TV will listen to a ‘0’ RC. Press and hold both the menu and digit “0” button on the RC for about
five seconds to assign the remote to the number.
[Digit 1]
The TV will listen to a ‘0’ RC. Press and hold both the menu and digit “1” button on the RC for about
five seconds to assign the remote to the number.
[Digit 2]
The TV will listen to a ‘0’ RC. Press and hold both the menu and digit “2” button on the RC for about
five seconds to assign the remote to the number.
The same process can be applied for all 10 digits on the remote control.
Press and hold the OK button for about five seconds to check on the current color of the Multi Remote setting for
the TV and the user remote.
[MyChoice]
In this manual we will cover only the configuration of MyChoice on TV, all details about the account and credit are
covered in a different manual. Please contact your TP Vision country sales manager to setup an account and buy the
credits.
During the installation of the TV sets please collect the following information:
Room number
TV model
Serial number
101
32HFL5008D/10
FZ1A
Room number, TV model and serial number are required on the MyChoice website when the rooms are configured.
Make sure that all values are correct because the MyChoice website is generating pin codes based on this
information. You can gather all these details during the installation and afterwards enter them in the administration
part of the MyChoice website.
How to configure the MyChoice is described below:
1.
The most important step for MyChoice is the clock. If the clock is not defined or TV doesn’t have the correct
time, MyChoice will display the following message:
MyChoice is not available, please contact the reception.
Summary of Contents for 26HFL5008D/12
Page 17: ...16 ...
