Philips 241P4QPYKEB/00, Service Manual

Page: 62 / 85

ġ
ġ
ġ
62 241P4QPYK LCD
ġ
General Product Specification
ġ
Video dot rate:
241P4QPY :
Analog: RTD 2486RD Integrated 8-bit triple-channel 210MHz ADC/PLL (over 2048x1152@60hz
input), High resolution true 64 phase ADC PLL, YPbPr support up to HDTV 1080p
resolution.
Digital: DVI Single link on-chip TMDS receiver up to 165MHz; DP Support 4 lanes digital input,
each lanes speed up to 1.62Gbps Hz and 2.7Gbps Hz
Power input: 90-264 V AC, 50/60
r
3 Hz
Power consumption:
On mode: < 52W (max.) for 241P4QPY
EPA 5.0 spec. < 33.97 watt
EPA 5.0 measure data < 30 watt
2.3 Ambient temperature:
0 q C - 40 q C
2.4 Power Range
FULL RANGE POWER SUPPLY 90 – 264 VAC
3 Electrical characteristics
Scaler should be capable of below items.
1) Scaler must support color engine for Image enhancement feature (SmartImage)
2) Scaler must have enough memory to support PerfecTune feature and Philips OSD
3) Scaler must support SmartContras, 20M:1 SCR preferred
4) VGA signal Auto adjustment:
Monitor automatically adjusts and optimizes resolution and frequency based on input signal
defined by “Source” function. “NO VIDEO INPUT” message to be displayed on screen while no
signal is detected. Monitor will automatically optimize resolution and frequency whenever
connected to different signal source. When press the “Auto”, the screen also show a status bar.
During adjustment period, a status bar will show on screen from 0% to 100% to indicate the
progress of adjustment.
Auto adjustment :
New timing & preset modes ( non- factory preset mode) should do auto
adjustment at first time detection and save the related data into memory.
Resolution
ʀ
800x600 , do not do auto auto adjustment.
Interface signals
1). D-Sub Analog