Philips 228C3LHSB/00, Service Manual

Page: 62 / 79

ʳ
ʳ
ʳʳʳʳʳ
ʳ
ʳ
ʳʳʳʳʳʳʳʳʳʳʳʳʳʳʳʳʳʳʳʳʳ 0.1 228C3 21.5” Wide 16:9 LCD Monitor
2011/05/23 PHILIPS 12 of 18
62 228C3LH LCD
General Product Specification
3.12 Pivot function
( option , refer to Quick specification table )
It needs to support AUTO PIVOT function with SmartControl PC application tool.
3.13 Hot-key definition
˗ˍ˯˘ˡ˚˯̀̂́˼̇̂̅ʳ
̃̅̂˽˸˶̇̆˯̆̃˸˶˯˛ˋ˯˻̂̇ʳ˾
3.14 Smart Image
˦̀˴̅̇˜̀˴˺˸ʳˣ̅̂˹˼˿˸ʳ
˗˸˹˼́˼̇˼̂́̆ʻˠˆʼ
3.15 PerfectTune II
(formerly FGA, FACTORY GAMMA Alignment)
A. PerfectTune must be done after warming 30 minutes at least.
B. PerfectTune must be performed after Auto Color.
C. PerfectTune must be conducted through DVI or scaler embedded patterns.
D. Delta E < 2.5
3.16 PowerSensor
( option, refer to Quick specification table; not require in 228C3L(H) )
ˣ̂̊˸̅ʳ˦˸́̆̂̅ʳ
˙̈́˶̇˼̂́˴˿ʳ˥˸̄̈˼̅˸̀˸
3.17
Smart Power
( option, not require in 228C3L(H) )
To reduce the power by adjusting backlight , contrast and color.
Algorithm is provided by Supplier.
3.18
SmartResponse
To enhance the Response time when Gary to Gary.
When SmartResponse= on, Response time = 2 mSec (typ.)
OD will only work
after 3 frames pass to pretend user see side effect.
When smart Image set to off and color temp set to User define , OD function will work
immediately.
4 Visual characteristics
4.1 Test conditions
Unless otherwise specified, this specification is defined
under the following conditions.
(1) Input signal : As defined in 3.3, 1920 x 1080 non-interlaced mode (1920 x 1080@60 Hz), signal
sources must have 75 ohm output impedance.
(2)