ʳ
ʳ
ʳʳʳʳʳ
ʳ
ʳ
ʳʳʳʳʳʳʳʳʳʳʳʳʳʳʳʳʳʳʳʳʳ˃ˁ˄
222E2 21.5” Wide FHD LCD Monitor
2010/02/05 PHILIPS 17 of 30
222EL2 LCD
71
General Product Specification
3.14.2
3.15
Smart response (over drive) [ N/A in 222EL2]
Response time < 2 msec GtG (Typical),
4 Visual
characteristics
4.1 Test
conditions
Unless otherwise specified, this specification is defined under the following
conditions.
(1) Input signal
: As defined in 3.3, 1920x1080
non-interlaced mode (1920X1080@60Hz 148.5MHz), signal
sources must have 75 ohm output impedance.
(2) Luminance setting : controls to be set to 250 nits with
full screen 100 % duty cycle white signal
(3) Warm up: more than 30 minutes after power on with signal supplied.
(4) Ambient light: 400 -- 600 lux.
(5) Ambient temperature: 20 ± 5
q
C
4.2 Brightness
Follow Panel specification.
4.3 Image
size
Actual display size
473.76 mm x 296.1 mm
4.4 Brightness
uniformity
Set contrast at 100% and turn the brightness to get average above 300 nits
at centre of the screen.
Apply the Fig 1, it should comply with the following formula:
B_min
X
100%
>75%
B_max
Where B_max =Maximum brightness
B_min = Minimum brightness
Summary of Contents for 222EL2SB/00
