89
Meridian 1
7.7 Slant on Front Bezel
≦
4.0 mm
7.8 First Enclosure Request
Shielding cover should fulfill international standard
7.9 Resins
y
RoHS
requirements.
y
WEEE
requirements
y
Resin type / selection refer to “ Plastic-Philips Pool monitor”
7.10 Paint Used
y
RoHS
requirements.
y
WEEE
requirements.
y
If new painting type need to implement, refer to UN-D 1235
7.11 Plastic Mold Tooling
y
Tooling to be designed to minimize cosmetic defects induced by molding process (sink, blush, weld lines, gate
marks, ejector marks, etc.). Reference to “TYV 61-90007”.
y
Painting to cover up cosmetic defects due to molding is strongly discouraged.
y
China RoHS mark requested.
y
Design of a separated room on front cabinet by using wall, rib, sponge...etc. for ensuing both speaker enclosure
(RH/LH) is segregated
7.12 Plastics Flammability
y
All Plastics to be Flame Retardant UL 94- HB or Better.
y
All major plastic parts (bezel, back cover, base) is better to be molded from same resin
7.13 Texture/Glossing of Housing
y
The texture area and texture no should follow Philips make-up sheet.
y
The exterior surfaces shall have a uniform texture.
y
Philips must approve the mold texturing.
y
Detail document for texture refer to UAN-D 249 and UN-D 600.
y
Glossy surface >= 80 gloss units.
7.14 Base Tilt / Swivel Range
y
Tilt
-5
°
+2/-0
°
(forward) +20
°
+0°/-2°(backward)
y
Swivel Range
Nil
y
Base Range
Should be directly disaasembled from main body, so as for easy install
the set to wall mount.
y
Tip over
10° minimum in worst case, base dimension designed so that ID and tip
over requirements can be met
7.15 Movement of Unit with Base
y
Base must have non-marring, non-staining feet.
y
Unit must tilt up and down with no “Stick / Slip”.
y
Base must provide sufficient friction to hold unit in desired position after adjusting tilt.
